FAQs Frequently Asked Questions about Our Products and Solutions

When will a data logger reset the switched 12 V channel (SW12)?

The data logger will not reset the SW12 unless it is done under program control using the SW12() or PortSet() instructions, or unless the data logger compiles or recompiles a program. This could be done when a new program is sent to the data logger, or if the power is cycled.

This was helpful

FAQs Home

Similar FAQs

If a device or sensor is not available for selection in the Short Cut program, how can it be added?
How long can the cables be between networked data loggers?
To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
Is it possible for LoggerNet to collect data from a data logger and then SFTP it to a server?
Is there a way of configuring the FTP, HTTP, and Telnet services remotely on a CR1000 or CR3000 with an NL115?
How can LoggerNet be upgraded to LoggerNet Admin?