FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1717 total: showing 341-360)

What is the difference between the Connect screen graph and the RTMC chart?
How can RTMC data be published to a web page?
Can RTMC be used to create a real-time XY plot of two sensors?
Can a SetPoint box in RTMC be used to change a multiplier and offset that are programmed in Edlog or CRBasic?
For RTMC, how can the SetPoint component variable be configured to RW (read/write)?
How can data from a BACKUP file and a DAT file both be displayed in RTMC graphs?
Is there a way to have two scales on a single graph in RTMC? For example, can a Celsius scale be on one side with a Fahrenheit scale on the opposite side?
If multiple data loggers are running the same program, is there a way to use only one switch in RTMC to toggle the same variable in all data loggers?
Can a value be read from one data logger and then be sent to another?
Where does RTMC display data from?
What is the data source for RTMC?
Is there anything special to know about an SDM-SIO1 used with an RS-422 cable?
Is the SDM-SIO1 compatible with Modbus?
How does an SDM-SIO1 act in conjunction with a data logger?
To replace the transducer heads on an SR50A-L, is there a torque specification for the screws?
Can the SR50A-L be recalibrated?
If an SR50A-L is used to measure snow depth at a site that has wind, rain, and extreme changes in temperature, which results in condensation, what can be done to ensure the sensor operates properly?
Can an SR50A-L be hardwired to a data logger that is 2,000 ft away with no direct line of sight?
How can snow depth less than 0.5 m be measured using an SR50A-L?
Can the range operation of the SR50A-L be increased?

Previous Next