FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1947 total: showing 521-540)

When should the light on the CH100 come on, and when should it be off?
When a CH100 approaches the maximum current output, does the voltage stay at a constant 12 V up until that point? Or does the voltage begin to taper off as it reaches the maximum current output?
Is the CH100 compatible for use with two BP24 battery packs in series to provide 24 Vdc?
Is a BP24 with a CH100 equivalent to a PS24?
What is the current consumption of the CH100 or PS100?
Can the A205 be used to determine whether there are communication issues between the wireless sensor and the wireless sensor base?
Can the A205 be used to determine whether a wireless sensor is a repeater in a wireless sensor network?
Can the A205 be used to determine signal strength (RSSI) of a wireless sensor?
To use the A205 with a wireless sensor interface and a wireless sensor base, is direct line of sight necessary?
What type of wind screen can be used for a tipping bucket rain gage?
If a phone line is shared with a seismograph that transmits data when it is called from a computer, is it possible to avoid interference by having the COM220 call out rather than transmit after receiving an outside call?
Why would installing a COM220 on a data logger disrupt the connection to a met station?
Can a COM220 be used to connect to a remote DCP using RS-232 through a cellular telephone?
Is there a way to remotely change the number of rings from two to four on the COM220?
What type of cable is compatible with the COM220 and can be used for a 2 km distance?
Can a COM220 and a spread-spectrum radio coexist on the CS I/O port of a PakBus data logger?
What is involved to install the COM220?
Is it possible to use a COM220 with a data logger to send text messages to a GSM phone?
Is it possible to make an SMS (short message service) with the COM220?
Can a COM220 be used to activate a solid-state power switch?

Previous Next