FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1947 total: showing 481-500)

Is it possible to purchase replacement sensor cables and bearings for the 014A-L? If so, can they be replaced by the user?
Does the 18529 Morningstar Regulator have the Low Voltage Disconnect feature?
What would cause an HS2 to display a DISK FULL error?
Is a 3WHB10K needed to connect five three-wire temperature probes to an AM16/32B
Can eight PT100 sensors be connected to a CR1000 using a 3WHB10K?
Can three-wire PT100 sensors only be used with three-wire half-bridge modules, or can they also be used with four-wire half-bridge modules?
If there is no manual for the 4WHB10K, where is there information about four-wire half-bridge measurements?
Is there a guideline for calibration or calibration verification of the CS547A-L probes?
Can the CS547A-L be cleaned out with a brush?
What is the purpose of the ionization correction code?
What is a possible installation option for a CS547A-L in a very flashy stream with high peak runoffs followed by a base flow of 1 to 2 cubic feet per second?
What is the communications interface with the CS547A-L?
With a CS547A-L, how can electrical conductivity measurements be corrected for temperature spikes?
What is the maximum number of CS547A-L probes that can be connected to an A547 interface?
Can multiple CS547A-L probes be wired to one data logger if there is one A547 interface for each probe?
Can CS547A-L probes get accurate readings when they are in hyporheic wells where the water level does not change quickly?
What are the units of conductivity output by the CS547A-L?
Does the CS547A-L need to remain submerged for long-term accuracy? For example, can it be used in an ephemeral stream?
Can the CS547A-L be used in saltwater?
Can a CS547A-L be used in arctic seawater where the temperature drops to -2°C?

Previous Next