All FAQs (1717 total: showing 1681-1700)
- How are readings obtained from the 229?
- Is calibration of the 229 available?
- If several 229 probes begin returning very low positive and negative values for dT, what might be the cause?
- How should the AM25T be used?
- Can the AM25T be connected to an analog input channel on a device other than a data logger, such as a programmable logic controller (PLC)?
- How can the data logger build a text string and send it out the RS-232 port?
- Can a point-multipoint network be built using RF401 radios with a base and three remote terminals, a data logger at each terminal, a COM210 modem, and a remote PC with LoggerNet software?
- When trying to start LoggerNet, what might cause the "Unable to start program because the Campbell Scientific communications server is already running" message?
- After installing an upgrade to the current version of LoggerNet, why does the Toolbar no longer show all the buttons?
- Why is the battery in the BP12 and BP24 assembly taller than the bracket?
- Where is the Transformer tool in LoggerNet?
- What is the stated accuracy for the thermocouple (temperature measurement) in a 229 Water Matric Potential Sensor?
- Can the RF401A be used in an RF400 network?
- What is the natural frequency of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
- What is SDI-12?
- What is the frequency response of the FW05 thermocouple?
- Which rain gage does the CS705 work with?
- What is the procedure for orienting a wind monitor (05103, 05305, 05108, or 05108-45) to the cardinal directions so that the wind direction readings are correct?
- Does Campbell Scientific software contain spyware?
- What are the options for purchasing LoggerNet 4?
Previous
Next