All FAQs (1948 total: showing 161-180)
- After the release of the CR1000X, will the CR1000 continue to be sold and supported?
- Can a CS320 be calibrated to a smaller range to measure only PAR (photosynthetically active radiation)?
- How can the CS320 be mounted if the 18356 leveling base is not used?
- Is it possible to read the output from a CS320 in a 4 to 20 mA form?
- On routine site visits, how can the calibration of the CS320 be checked?
- How often does the CS320 need to be recalibrated?
- How long can the CS320 cable be?
- What is the difference between a thermopile pyranometer and a silicon photocell pyranometer?
- How can an end user simulate a lightning strike to an SG000 or CS110?
- How many AM16/32B multiplexers can be connected to a data logger at the same time?
- Which weather measurements are needed when calculating reference evapotranspiration?
- If a CH200 or PS200 is hooked up to both solar and ac power supplies, which power supply does the device use?
- If a CH150 or PS150 is hooked up to both solar and ac power supplies, which power supply does the device use?
- Is the IRGASON® well suited for all environments?
- Is the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH well suited for all environments?
- In terms of a network link interface, what is "bridge mode"?
- For the CPEC200, is the heater on the vortex intake controlled the same way as it was prior to the addition of the vortex intake?
- Has the vortex intake changed the way the pump for the CPEC200 works?
- With the new vortex intake, has the power drain changed for the pump module fan for the CPEC200?
- How is the intake pipe of the CPEC200 heated?
Previous
Next