All FAQs (1712 total: showing 1561-1580)
- If the wind speed on the WXT520 constantly reads 0, what should be done?
- Is LoggerNet software needed to download the data from a data logger remotely?
- Can the constants located within the ConstTable/EndConstTable instructions be edited?
- Can the display timeout and contrast be programmed by the CRBasic Editor?
- Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
- Is it possible to connect the CR800, CR850, CR1000, or CR3000 to a SCADA system through a Modbus RS-485 protocol?
- How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU server?
- Is it possible to overwrite an existing array using a CR850?
- Can the NL201 be put into bridge mode via the settings of a CR800 or CR850?
- Can the CR850 be programmed to show information in the display without using the keyboard?
- Can a new program be installed on a data logger using a laptop and PC200W?
- When no excitation is commanded, are the voltage excitation ports on the data logger isolated from the data logger ground?
- Instead of saving the data of a CRBasic data logger to one large file, how can it be saved in daily, hourly, or half-hourly files?
- If a computer does not have any serial ports, how can software (such as LoggerNet, PC400, PC200W, or Device Configuration Utility) talk to the data logger?
- Can external devices be switched on and off using a datalogger?
- If a device or sensor is not available for selection in the Short Cut program, how can it be added?
- Can the datalogger be damaged by wiring the sensors to the wrong ports?
- How can a floating point value be cast as a long integer?
- How can data that has been transmitted from a data logger to LoggerNet then be transmitted to a webhost that displays the data graphically?
- Is there a way to only record measurements during the daytime and put the data logger in sleep mode during the nighttime to conserve power?
Previous
Next