All FAQs (1712 total: showing 1421-1440)
- Is there a GPS interface that can be used to keep a data logger synchronized with GPS time?
- If an RF modem is used to communicate with a data logger and a PC running LoggerNet, but the modem baud rate is one third of the data logger baud rate, is that a problem?
- Why might a data logger refuse having a file uploaded to it?
- Is there a free software package that allows the generation of programs that can sample data on the RS-232 or COM port of the data logger?
- If a data logger OS has not been upgraded in a long time, can the most current OS be downloaded, or do the upgrades need to be done incrementally?
- Can two data loggers be connected over the RS-232 port, or do they need to use the COM ports to connect?
- How often is the lithium battery voltage measured by the CR1000?
- If a data logger has not been used in a while and the internal battery is low, will the battery recharge if the data logger is connected to a power supply? Or does the battery need to be replaced?
- Is data lost when the data logger battery runs out of power in the field or is disconnected, and a “table definitions out of date” error message appears upon powering up?
- Which CRBasic instruction is used to activate the 7321 relay?
- Can a data logger accept PakBus™ connections from multiple terminals simultaneously?
- Can an RS-232 device be directly connected to the CS I/O port of a data logger?
- How can the data logger be used to produce analog voltages?
- What is the difference between the various bridge measurements?
- What might cause data logger clock issues?
- What might cause a data logger to not store data at a particular time, such as midnight?
- What might cause error messages such as “transaction failure” and “unreachable destination” when trying to connect a data logger and a PC using a serial or USB to RS-232 cable?
- How can variables be saved so that they are available for use after the data logger power has been removed and the data logger has been powered up again?
- What is the minimum scan interval of the CR1000, CR800, CR850, or CR3000?
- What is the operating voltage of the CR1000, CR800, and CR850?
Previous
Next