FAQs Frequently Asked Questions about Our Products and Solutions

How is the baud rate set using PC400?

When using PC400 to connect to a data logger on an RS-232 port, the baud rate must be matched. This is done through the PC400 data logger settings.

This was helpful

FAQs Home

Similar FAQs

If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
Is LoggerNet software needed to download the data from a data logger remotely?
Can PC400 operate on a 64-bit system?
In PC400, in the Monitor Data tab, how can the label (InputLocation) be renamed?
Can the CSAT3/3A/3AH give a time stamp with each measurement value?
How do the PC200W, PC400, VisualWeather, and LoggerNet software options compare?
What is the best way to communicate wirelessly between a PC and a CR3000?