FAQs Frequently Asked Questions about Our Products and Solutions

Is there a way to allow a user to change constants in a CR800, CR1000, CR3000, or CR6 program without allowing the user to make other program changes?

In OS 24 (CR6 OS 01) and later, a user can change constants from the CR1000KD or a terminal emulator without touching the program. The program must contain a ConstTable/EndConstTable construction for this to occur. Because the program does recompile, collect the data first.

This was helpful

FAQs Home

Similar FAQs

If a device or sensor is not available for selection in the Short Cut program, how can it be added?
How long can the cables be between networked data loggers?
To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
Is it possible for LoggerNet to collect data from a data logger and then SFTP it to a server?
Is there a way of configuring the FTP, HTTP, and Telnet services remotely on a CR1000 or CR3000 with an NL115?
How can LoggerNet be upgraded to LoggerNet Admin?